Jelly Builder 10
MGPO-10R
Stays exactly where it is applied, Peach Clear
Item number:
8310r
Effect:
–
Color:
Viscosity:
low viscosity
Opacity:
clear
Science & Quality “Made in Germany”
Reliable delivery time of 7 weeks
Secure worldwide delivery with UPS, GLS & DACHSER
Product details
Description
Jelly Builder 10 is a low-viscosity, rose-coloured modelling gel (jar clay, not visible on the nail) that stays exactly where it is applied. The thixotropic, resistant formulation does not run into the nail fold, is pinchable and is particularly suitable for acrylic changeovers as well as precise setups.
- Low viscosity – fine, controllable modeling
- Thixotropic – does not run and does not run into the nail fold
- Pure modelling gel – ideal for precise build-ups and shaping
- Very resistant – stable model layers even under stress
- Pinchbar – supports perfect C-curve and clean shapes
- Perfect adhesion – in combination with Polystone adhesive gels, no lifting
- No noticeable heat build-up – comfortable during curing
- Non-yellowing – permanently clear, stable result
- Versatile use – tip, stencil and refill technology
- Curing: UV 120s / LED 60-120s
Application
Clean the prepared nail with nail cleaner, then apply Nail Prep and allow to air dry. Then apply the primer and let it air dry as well. Then apply Base Coat evenly thinly and cure without removing the dispersion layer. To build up the nail, apply the desired build-up gel and harden again. Only remove the dispersion layer with Cleaner when no more gel layer is to be applied. Then make file corrections and dust the nail. Then coat the nail with Colour or French and harden without wiping off the dispersion layer. Finally, seal with a top coat and cure. If the sealer hardens with a dispersion layer, remove it with a cleaner at the end.
Note
All information on ingredients and product properties is non-binding and subject to the final specification. Color and effect representations may differ from the original depending on the screen display. All products are tested under the following standard conditions: UV lamp: 4 x 9 W, 120 sec. Combi-LED lamp: 48 W, 60 sec. Due to the large number of different lamp types and
For application variants, we recommend that you carry out your own tests in order to test the best application and curing conditions under the given conditions.
