High-Strength Builder 3
MGFG-03
Builder gel with fiberglass properties for extra stability, rosé clear
Item number:
1703
Effect:
–
Color:
Viscosity:
medium viscosity
Opacity:
clear
Science & Quality “Made in Germany”
Reliable delivery time of 7 weeks
Secure worldwide delivery with UPS, GLS & DACHSER
Product details
Description
High Strength Builder 3 is a high-viscosity, crystal-clear modelling gel with fibreglass function (without fibreglass fibres) for extra stable, resistant modelling. The rose-coloured crucible shade is not visible on the nail; the gel is pinchable, does not run into the nail fold and remains colour-stable without yellowing.
- High viscosity & rosé clear – maximum control with precise setups
- Fiberglass function without fibers – high stability with crystal clear optics
- Very resistant – suitable for heavily used models
- Very good self-adhesion – secure hold, no lifting
- Thixotropic / does not run into the nail fold – clean work right to the edge
- Pinchbar – perfect C-curve and dimensional stability
- No noticeable heat build-up – pleasant during curing
- Colour-stable & non-yellowing – permanently clear result
- Curing: UV 120s / Combi lamp 60–90s
Application
Clean the prepared nail with nail cleaner, then apply Nail Prep and allow to air dry. Then apply the primer and let it air dry as well. Then apply Base Coat evenly thinly and cure without removing the dispersion layer. To build up the nail, apply the desired build-up gel and harden again. Only remove the dispersion layer with Cleaner when no more gel layer is to be applied. Then make file corrections and dust the nail. Then coat the nail with Colour or French and harden without wiping off the dispersion layer. Finally, seal with a top coat and cure. If the sealer hardens with a dispersion layer, remove it with a cleaner at the end.
Note
All information on ingredients and product properties is non-binding and subject to the final specification. Color and effect representations may differ from the original depending on the screen display. All products are tested under the following standard conditions: UV lamp: 4 x 9 W, 120 sec. Combi-LED lamp: 48 W, 60 sec. Due to the large number of different lamp types and
For application variants, we recommend that you carry out your own tests in order to test the best application and curing conditions under the given conditions.
